Chapter Iii Operation Introduction; Pre-Amplification Preparation; Start Of Amplification; Amplification Exception Handling - Baumgartner MedRhein Pluslife POC-NAT Instrucciones Del Producto

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 35

Chapter III Operation Introduction

1. Pre-amplification preparation

Connect the power supply, press the power button to start the device and enter
warm-up state. After about 2 mins, warm-up is completed and the device enters
standby state (Figure 1).

2. Start of amplification

Insert the reaction card into the device and close the top cover. Press the power
button to start amplification.

3. Amplification exception handling

When the power indicator flashes and the beeper sounds simultaneously, the
device is in exception state, press the button for 3 seconds to end the test.

4. End of amplification

After amplification, you can start the next test directly, or press the button for
3 seconds to turn off the device.
Figure 1
- 13 -

Publicidad

Tabla de contenido
loading

Tabla de contenido