Mitsubishi Electric PAC-YT32PTA Manual De Instalación página 3

CAUTION If the screws are overtightened, it could cause the body to deform or crack.
NOTE: - Choose a flat plane for installation.
- Fasten the switch box at more than two places when installing directly on the wall.
- When reinstalling on the wall, fasten securely using anchors.
(5) Fit the cover in place.
• Connect the wires in accordance with 4 Wiring Method .
- When the cover is fitted, it will make a clicking sound. Make sure it is fitted securely.
CAUTION
- Peel off the protective sheet from the controls when using the program timer.
NOTE: A protection sheet is stuck to the operation section. Peel off this protection sheet before use.
4 Wiring Method
(1) Wiring with the Remote Controller
• Carry out wiring from the remote controller.
• Insert the 5-wire cable of the remote controller to the timer connector. (The
part shown by the arrow in the figure at right.)
• The following 2 types of 5-wire cable are packaged, so use the cable which
matches with your remote controller.
1 Connector small – small type
2 Connector large – small type
• After connecting, the cable passes the knockout hole. (See the figure at right.)
• Close the cover.
(2) Wiring the Program Timer
• Insert the 5-wire cable's connector in the remote controller connector on the
bottom of the program timer. (The part shown by the arrow in the figure at
right.)
• The 5-wire cable connects to the remote controller connector on the program
timer. (See the figure at right.)
• Pass the wire along the bottom of the program timer as shown in the figure at
right, running it through the knockout hole in the cover.
• Close the cover.
(3) Seal the wire lead-in holes with putty to prevent condensation, water drops, worms, etc. from getting inside.
• If the program timer is mounted directly on the wall, seal the knockout holes in the top case with putty.
• If the remote controller is mounted on the switch box and the program timer is wired from it, seal the joints between the remote
controller, wire conduit and program timer with putty.
Program Timer
When installing directly on the wall
1
Remote Controller
Seal around here with putty.
5-wire cable
Remote Controller
Connector
Switch box
Wiring
Bushing
pipe
Lock nut
Seal around here with putty.
If the remote control wire is run from the switch box for installation
Timer Connector
From Remote
Controller
Remote Controller
Connector
Remote Control cord
3