Polygroup SUMMER WAVES Manual Del Usuario página 2

Before assembling your product, please take a few minutes to check the contents and become familiar with all the parts.
A. Mounting The Surface Skimmer To A Frame Pool
1
1
5
Insert the Frame Pool Holding Frame 1 into the
Skimmer Canister 4 . Put the Lock Nut 5 onto
the screw hole of the Skimmer Canister 4 .
4
Clamp lock screw
Hang the Frame Pool Surface Skimmer
Assembly over the top pole of the frame
pool using the Frame Pool Holding
Frame and then turn the Clamp lock
1
screw, by hand, clockwise to mount the
Surface Skimmer to the frame pool.
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
2
SETUP INSTRUCTIONS
2
4
Turn the Lock Nut 5 , by hand, clockwise to
tighten the Frame Pool Holding Frame
the Skimmer Canister
5
7
Connect the Skimmer Fitting
the pool wall. Connect one end of the hose (not
included) onto the hose connector on the bottom
of the Skimmer Canister 4 and fasten the hose
with a hose clamp (not included). Connect the
other end of the hose onto the hose connector on
the Skimmer Fitting
hose clamp (not included).
MST. Extended operating days and hours during peak season requirements.
OWNER'S MANUAL
(The Hose and Hose Clamps are not included)
1
5
onto
1
.
4
4
on the inside of
7
and fasten the hose with a
7
3
Insert the Skimmer Basket 6 into the Skimmer
Canister 4 .
6
1
5
Tighten
Loose
Loosen the Lock Nut 5 , by hand, turning
counterclockwise and adjust the position of the
Skimmer Canister on the Frame Pool Holding
4
Frame 1 . The depth/position of the Skimmer
Canister should be set so that the top surface of
4
the pool water is between the MIN/MAX water level
markings on the Skimmer Canister
Lock Nut 5 , by hand, turning clockwise to hold the
Skimmer Canister 4 at the correct depth/position.
6
4
4
. Tighten the
4