Polygroup SUMMER WAVES Manual Del Usuario página 3

B. Mounting The Surface Skimmer To A Ring Pool
1
5
3
2
Insert the Ring Pool Holding Frame Front 2 into the
Ring Pool Holding Frame Rear 3 and then put
the Lock Nut 5 into the screw hole of the
Ring Pool Holding Frame Front . Tighten the Lock
2
Nut 5 , by hand, turning clockwise until secure.
See 'NOTE' in above image.
4
5
3
Push
3
Hang the Ring Pool Surface Skimmer Assembly over
the top of the inflatable ring and then loosen the Lock
Nut 5 , by hand, turning counterclockwise. Push
the Ring Pool Holding Frame Rear piece
Ring Pool Holding Frame Front piece
Release Button to adjust the Ring Pool Holding Frame
Rear until it fits snugly onto the inflatable ring. Tighten
the Lock Nut , by hand, turning clockwise until
5
secure.
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
2
5
Insert the Ring Pool Holding Frame into the Skimmer
Canister 4 and then put the Lock Nut 5 into the
screw hole of the Skimmer Canister 4 . Tighten the
Lock Nut 5 , by hand, turning clockwise until secure.
5
Tighten
5
Release Button
Connect the Skimmer Fitting
the pool wall. Connect one end of the hose (not
included) onto the hose connector on the bottom
into the
of the Skimmer Canister 4 and fasten the hose
. Push the
with a hose clamp (not included). Connect the
other end of the hose onto the hose connector on
the Skimmer Fitting
hose clamp (not included).
MST. Extended operating days and hours during peak season requirements.
(The Hose and Hose Clamps are not included)
4
4
7
on the inside of
7
7
and fasten the hose with a
7
OWNER'S MANUAL
3
Insert the Skimmer Basket 6 into the Skimmer
Canister 4 .
6
2
Tighten
Loose
Loosen the Lock Nut 5 , by hand, turning
counterclockwise and adjust the position of the
Skimmer Canister on the Ring Pool Holding
4
Frame Front piece . The depth/position of the
Skimmer Canister should be set so that the top
4
surface of the pool water is between the MIN/MAX
water level markings on the Skimmer Canister
Tighten the Lock Nut 5 , by hand, turning clockwise
to hold the Skimmer Canister 4 at the correct
depth/position.
6
4
5
4
.
4
3