INSTRUCTIONS
1. Carefully unpack the replacement kit.
2. Using the provided screwdriver, carefully remove the screws
from the perimeter edge of waffle plate/s. Lift plates up and off
the housing. Slight force may be needed to release the plates
completely. Discard the old plate/s and screws.
3. Starting with the lower grid, place the new plate onto the housing
by aligning rear and front projections onto the base. The wider
projections will fit into the rear.
4. Install 1 large screw into the slot located near the handle.
5. Install the smaller screws around the perimeter.
6. Repeat steps 2–5 for the upper grid replacement.
Waring
Commercial warrants every new Waring
®
to be free from defects in material and workmanship for a period of one
year from the date of purchase when used with foodstuffs, nonabrasive
liquids (other than detergents) and nonabrasive
semiliquids, providing it has not been subject to loads in excess
of the indicated rating.
Under this warranty, Waring
which, upon our examination, is defective in materials or workmanship,
provided the product is delivered prepaid to the Waring Service Center at:
314 Ella T. Grasso Ave., Torrington, CT 06790, or any Factory Approved
Service Center.
This warranty does not: a) apply to any product that has become worn,
defective, damaged or broken due to use or due to repairs or servicing
by other than the Waring Service Center or a Factory Approved Service
Center, or due to abuse, misuse, overloading or tampering; or b) cover
incidental or consequential damages of any kind.
Warning: This warranty is void if appliance is used on Direct Current (DC).
LIMITED ONE YEAR WARRANTY
(U.S. and Canada only)
Commercial will repair or replace any part
®
Commercial Waffle Maker
®
WARING COMMERCIAL
314 Ella T. Grasso Ave.
Torrington, CT 06790
8