Clarion CMM-10 Manual Del Propietário página 4

FCC COMPLIANCE STATEMENT
This device complies with Part 15 of
the FCC Rules. Operation is subject
to the following two conditions:
(1) this device may not cause harmful
interference, and (2) this device
must not accept any interference
received, including interference that
may cause undesired operation.
These limits are designed to provide
reasonable protection against
harmful interference in a residential
installation.
This equipment generates, uses and
can radiate radio frequency energy
and, if not installed in accordance
with the instructions, may cause
harmful interference to radio
communications. However, there is
no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, the user is encouraged to
try to correct the interference by one
or more of the following measures:
- Reorient or relocate the
receiving antenna.
- Increase separation between the
equipment and the receiver.
- Connect the equipment to an
outlet on a circuit different
from that to which the receiver
is connected.
- Consult the dealer or an
experienced radio/TV technician
for help.
Any changes or modifications
not expressly approved by the
party responsible for compliance
could void the user's authority
to operate this equipment.
CMM-10-10i_MAN_all.indd 4 CMM-10-10i_MAN_all.indd 4
SAFETY CONSIDERATIONS
• Only use this product in vehicles with
12 volt, negative-ground electrical
systems. This product is not certified
or approved for use in aircraft.
• Mount this product securely to
prevent damage or injury in
severe conditions.
• Do not replace the power wire fuse
with one of a different value.
Never bypass the fuse.
• Listen to your audio system at
levels appropriate for operating
conditions and hearing safety.
INSTALLATION CONSIDERATIONS
• Installation requires appropriate
tools and safety equipment.
Professional installation
is recommended.
• This product is water-resistant. Do
not submerge or subject to high-
pressure water spray.
• Before installation, turn off the audio
system and disconnect the battery
system from the audio system.
• Install in a dry, well-ventilated
location that does not interfere with
your factory-installed systems. If a
dry environment is not available,
a location that is not exposed to
heavy splashing may be used.
• Before cutting or drilling, check
for potential obstacles behind
mounting surfaces.
• Carefully route all system wiring
away moving parts and sharp
edges; secure with cable ties or
wire clamps and use grommets
and loom where appropriate to
protect from sharp edges.
4
2/24/23 8:56 AM 2/24/23 8:56 AM