Publicidad
Idiomas disponibles
Idiomas disponibles
The power supply must match the technical
specifications of the power tool, and it must be
grounded.
The power cord must be plugged into a socket with
differential protection. The circuit breaker must be set
to trip when there is a maximum fault current of 30mA.
Do not expose the power tool to rain or use it in wet or
moist environments. The presence of water in a power
tool increases the risk of damage and electric shock to
the user.
Never use the power cord to pull, carry or unplug the
power tool. Damaged power cords increase the risk of
electric shock.
Keep the power cord and plug away from heat sources,
oil and sharp objects.
Check the condition of the power cord regularly, if it is
damaged, it must be replaced or repaired by a qualified
technician. Do not touch it and unplug it immediately.
Never use the power tool with a damaged power cord.
Never change the power cord plug and use a socket
which is compatible with the plug. Do not use any kind
of socket adaptor.
If the power cord is too long, the electric current may
drop, causing a decrease in the quality of the welding.
The tension must be kept stable.
The use of extension cords to plug the power cord is not
recommended. However, if you use an extension cord,
you should take some precautions, such as:
▪ If you use the power tool outdoors, use only
extension cord suitable for outdoor use. The use of a
suitable extension cord reduces the risk of electric
shock;
▪ The cross-section of the extension cord's cables shall
be proportional to the length and with the same
characteristics as or larger than the welding
machine's power cord;
▪ Do not use damaged extension cords. Examine the
extension cords before using them and replace if
necessary;
▪ Always unplug the extension cord before removing
the plug from the power tool;
▪ When using an extension cord reel, unroll the cord
completely;
Before you start working
Individuals who have not read the instruction manual
and are not familiarized with how to operate the
welding machine must not use it.
carried out by qualified personnel who are aware of all
the associated safety precautions.
Before welding, remove solvents, degreasers and other
combustible materials from the work area.
Ensure that ambient air does not contain high
concentrations of dust, acid vapours, gases or
flammable substances. We recommend special care
when performing repair work on pipes and containers
that contain or have been in contact with combustible
liquids or gases.
To ensure that you work with the power tool safely, you
should take into account a few precautions and
procedures before start-up:
▪ Check that the attached accessories are assembled
correctly and in good condition. Never use damaged
accessories;
▪ Replace defective or damaged parts as well as all
other used and worn out parts;
▪ Check that the safety devices are in perfect condition
and work properly. Never use the power tool if the
safety devices are missing, inhibited, damaged or
worn out;
Make all adjustments and work necessary for the
correct assembly of the power tool if you have any
questions or difficulties, contact your official dealer.
Welding must be
27
Publicidad
