Waferlock L701 Guia Del Usuario página 14

WAFERLOCK CORPORATION
Open Door With User Card
 Step 1
Approach the reader by a user card.
Open Door With Pin Code
 Step 1
Press any button to activate the keypad.
Note
• During entering PIN Code, if the users approach to the reader with a user card, the lock will be
interrupted then react to the user card rst.
• If an invalid code (Master PIN/PIN) has been entered to the lock more than 5 times, the anti-theft
function will be initiated for 3 minutes. During this period, the keypad will be locked.
• If enter the invalid code 1 time after 3 minutes, the anti-theft function will be initiated for
3 minutes again.
• The anti-theft counter will be reset once the valid PIN Code is entered to the lock. When the lock is
in Dual Mode, the counter will only reset when both valid PIN Code & valid user card are presented
to the lock.
• During the 3 minutes lock-up, a valid user card can still be used to access.
 Step 2
The Led light up.
If the card is valid (Programmed), 1 beep followed
by green light ashing 1 time.
If the card is invalid (Not programmed), 2 beeps
followed by red light ashing 2 times, then
standby.
 Step 2
Press previous programmed PIN Code, then
press # button.
If enter less than 4 digits or over 6 digits, 2
beeps followed by red light ashing 2 times,
then standby.
If code is programmed, 1 beep followed by
green light ashing 1 time.
12