JAROLIFT TDRC08W Instrucciones Originales página 20

PROGRAMMING
Setting the jog mode
You can conveniently control blinds in the "Jog mode". When you press the UP button, the blind does not immediately move
to the upper end position. The drive is controlled by briefly pressing it and thus opens the blind only step by step to open the
slats. The function is also used for convenient control of roller shutters to open the ventilation slits. Only when you press and
hold the UP button for longer than approx. 3 seconds is the drive controlled in "self-retaining" and the blind fully opened.
The example shown is exemplary and depends on the respective receiver type.
Please refer to the instructions of the receiver!
1. Select a learned channel on a transmitter that has already been learned.
2. Press the UP and DOWN buttons on the transmitter simultaneously.
3. Then press the STOP button 6 times.
4. Press the DOWN button within 10 seconds.
The motor will confirm the activation (deactivation) of the inching mode by a short
vibrate.
Taught-in transmitter:
Press the up and
down buttons
simultaneously.
To deactivate the jog mode, repeat the procedure.
DELETE WALL TRANSMITTER
ATTENTION!
All learned (programmed) stations are deleted!
Individual deletion of a station is not possible!
The example shown is exemplary and depends on the type of receiver concerned.
Please consult the receiver's operating instructions!
1. Press the UP and DOWN buttons of a taught transmitter simultaneously.
2. Then press the STOP button 6 times.
3. Press the UP button within 10 seconds.
The motor will confirm the deletion of the transmitters by vibrating briefly.
Taught-in transmitter:
Up and down but-
ton simultaneous-
ly press.
20
6 x Stop button
Press.
Press the stop
button 6 times.
Down - Press the
key.
Down - key press.
M
Engine vibrates.
M
Engine vibrates.