Publicidad
Idiomas disponibles
Idiomas disponibles
Initial Settings
2
Press c or d to adjust the brightness
level.
Each press of c or d increases or decreases
the brightness level. 0 15 is displayed as the
level is increased or decreased.
Setting the rear output and
subwoofer controller
This units rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (REAR SP :FULL) or subwoofer
(REAR SP :S/W) connection. If you switch the
rear output setting to the REAR SP :S/W, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (REAR SP :FULL). When rear
output is connected to full range speakers
(when REAR SP :FULL is selected), you can
connect the RCA subwoofer output to a sub-
woofer. In this case, you can select whether to
use the subwoofer controllers (low pass filter,
phase) built-in PREOUT :S/W or the auxiliary
PREOUT :FULL.
1
Press FUNCTION to select REAR SP.
Press FUNCTION repeatedly until REAR SP ap-
pears in the display.
2
Press a or b to switch the rear output
setting.
Pressing a or b will switch between
REAR SP :FULL (full-range speaker) and
REAR SP :S/W (subwoofer) and that status will
be displayed.
# When no subwoofer is connected to the rear
output, select REAR SP :FULL.
# When a subwoofer is connected to the rear
output, set for subwoofer REAR SP :S/W.
# When the rear output setting is
REAR SP :S/W, you cannot change the subwoofer
controller.
All manuals and user guides at all-guides.com
3
output or nonfading output (full-range
RCA output).
Pressing c or d will switch between
PREOUT :S/W and PREOUT :FULL and that
status will be displayed.
! Even if you change this setting, there is no
! If you change the subwoofer controller, sub-
! Both rear speaker leads output and RCA rear
Switching the telephone
muting/attenuation
Sound from this system is muted or attenu-
ated automatically when the signal from the
equipment with mute function is received.
! The sound is turned off or attenuated,
! Sound from this system returns to normal
1
Press FUNCTION repeatedly until Telephone
appears in the display.
Press c or d to switch the subwoofer
Notes
output unless you turn the nonfading output
(refer to Using nonfading output on page 37)
or subwoofer output (refer to Using subwoofer
output on page 36) in the audio menu on.
woofer output and nonfading output in the
audio menu return to the factory settings.
output are switched simultaneously in this
setting.
MUTE or ATT is displayed and no audio ad-
justment is possible.
when the muting or attenuation is can-
celled.
Press FUNCTION to select Telephone.
Section
09
41
En
Publicidad
