Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance & Cleaning
Catalytic walls (If your model has this accessory)
The catalytic walls are located on the left and right under the rails.
The catalytic walls expel unpleasant odours and provide increased oven performance. The catalytic
walls also absorb oil residues and clean the oven during operation.
Removing the catalytic walls
To remove the catalytic walls, you must remove the guides, as soon as you have removed the guides,
the catalytic walls will automatically release. The catalytic walls should be replaced every 2-3 years.
4
3
2
1
Installation and removal of the metal shelves
To remove the metal shelves, press the clips shown with arrows in the figure, first remove the bottom
and top from the installation position. To install the metal shelves,
reverse the procedure to remove the metal shelves.
Replacing the oven light
WARNING: To avoid electric shock, be sure to disconnect power to the oven before replacing the light.
First disconnect power to the product and make sure the product is cool.
Remove the glass guard by turning it as shown in the figure on the left side. If you have any difficulty in
turning it, the use of plastic gloves will help.
Then turn the lamp to remove it and place the new lamp in the same way. Replace the glass protection
of the product in the lamp holder and finish the replacement. The oven can now be used.
G9
Rack positions
It is important to position the rack correctly in the oven. Do not allow the
rack to touch the rear wall of the oven. The positions of the The positions
of the racks are shown in the figure below. You can place a deep or stan-
dard tray on the lower and upper metal shelves.
220-240 V, AC
15-25 W
52
E14
220-240 V, AC
15 W
English
infiniton.es
Publicidad
