Publicidad
Idiomas disponibles
Idiomas disponibles
Escali Digital Candy and Deep Fry Thermometer
Thank you for purchasing the Escali Digital Candy and Deep Fry Thermometer. This device
allows you to easily measure temperatures during the candy making or cooking process.
Please read the following instructions carefully before using your thermometer to ensure
proper use and care. If you have an issue with your thermometer, please contact Escali at
1-800-467-6408 to speak with a product specialist. We would appreciate the opportunity to
resolve any issues you may have before returning the product to the retailer.
Thermometer Components
and Display
1. Preset Name
2. Current Temperature Readout
3. Set Temperature Readout
4. Power Button ( )
5. Mode Button (M)
6. – Button
Operation
Before using your thermometer for the first time,
remove the battery insulating tab which is placed
between the battery and the battery terminal in
the battery compartment to prevent battery drain
during shipping (see "changing the battery" below
for detailed instructions on removing and replacing
the battery). Also be sure to remove the protective
display film from the display.
1. Press the POWER ( ) button to turn the thermometer on.
2. The unit of measure is preset at °F. This can be changed to °C
by pressing and holding the MODE (M) button for 2-3 seconds.
The thermometer will beep indicating that the unit of measure
has been changed.
3. Press the MODE button to select the desired candy stage or
deep fry temperature. The display will cycle through JELLY,
THREAD, S BALL, F BALL, H BALL, S CRACK, H CRACK, CARAMEL,
DP FRY1, and DP FRY2. Each candy or deep fry stage changes the
set temperature located in the bottom portion of the display. The current
temperature appears in the center of the display in larger numbers.
Note: The preset temperatures are temperatures for sea level and should
be adjusted based on your elevation. A simple rule of thumb is to reduce the
target temperature by 2°F for every 1,000 ft of elevation above sea level.
2
7. + Button
8. Alert LED
9. Battery Compartment
10. Heat / Splatter Shield
11. Vessel Clip
12. Probe
13. Probe Sheath (not pictured)
9
1
2
3
4
5
6
7
8
10
11
12
Publicidad
