San Jamar SCDGPC13 Hoja De Instrucciones página 3

DISPLAY CONFIGURATION INSTRUCTIONS
A)AttachedDisplayConfiguration
• ThescalecomesassembledintheAttachedDisplayConfiguration.
• Followsteps1-9untilthedesireddisplayconfigurationisassembled.
B)DetachedTabletopDisplayConfiguration
1.  U nscrewthetwo13 mm Screws connecting the Display Unit to the
Metal Display Mount and save the two 13 mm Screwsforstep8.
Skip steps 2-3 for "D) Standing Mount Display Configuration."
2.  U nscrewthetwo14 mm Screws that attach the Metal Display Mount
totheundersideofthescale.SpintheMetal Display Mount around so it
nolongerprotrudesfromtheundersideofthescaleandreattachitwiththe
Spacing Washersremaininginbetween.
C)WallMountedDisplayConfiguration
3. Add the Coiled Extension Cord to the Display Cord.
4.  R emovethefour7 mm ScrewsfromthetwoGrey Brackets located
underneath the Display Unit, and save the 7 mm Screwsforstep6.
5. Tuck the Display CordallthewayintoNotch Aatthetopofthe
Vertical Arm, and slide the Vertical Arm into the Display Unit. It will
beatightfit.
Reference "Vertical Arm" drawing on page 2 for Notch A.
6.  U sethefour7 mm Screwssavedfromstep4tofastentheVertical Arm
to the Display Unit.
Skip step 7 for "D) Standing Mount Display Configuration."
7. Attach the two Wall Mount Screwstoawallverticallyspacedand4cm
apart on center. Hang the Vertical Arm and Display Unit on the two
Wall Mount Screws.Pre-drill1/4inchdiameterholesfortheDrywall
Anchorswhenmountingontoadrywallsurface,or3/32inchdiameterholes
fortheWallMountScrewsalone.
D)StandingMountDisplayConfiguration
8.  U sethetwo13 mm Screwssavedfromstep1toattachtheMetal
Display MountinbetweentherubberfeetoftheVertical Arm. The
Metal Display Mount should protrude in the direction the Display
Unitisfacing.
9. Plug the Display Cord into the scale.
ATTENTION! Saveallunusedpartsforfuturereconfigurations.
3