Publicidad
Idiomas disponibles
Idiomas disponibles
The Bio-Circle Maxi (55D600) parts cleaners operate at 115VAC, 1Ph, 60 Hz with full-load amperage draw of 13 amps.
Walter offers cleaning fluids for most of the cleaning problems found in plants and maintenance shops. Any of the following
products work well in these parts cleaners.
•
CB100™ (L-155)
•
CB100™ ALU (L-158)
•
Bio-Circle™ L (L-78)
•
Bio-Circle™ Ultra (L-148)
•
Bio-Circle™ Aero (L-161)
•
Unit is shipped fully assembled.
•
Place unit on a smooth, level surface in a well-ventilated area.
•
Read all warnings posted on machine.
•
Inspect electrical control box, cord, and plug for wear or damage.
•
Do not use machine or add fluid if any wear or damage is noticed until impaired components are repaired or replaced.
Never work with equipment you feel may be unsafe. Contact your supervisor immediately if you feel a piece of
equipment is in an unsafe condition.
•
Install filter cartridge:
1.
Unscrew filter cartridge bowl.
2.
Remove clear plastic packaging from filter cartridge.
3.
Install new filter cartridge in the cartridge bowl.
4.
Re-attach filter cartridge bowl to filter body.
•
Failure to keep proper liquid level will result in burning out the pump and heater coil, creating a potential fire hazard.
To help prevent this, unit is equipped with a low liquid level device which will shut off the pump and heater. If solution
stops circulating and the green "READY" light is no longer illuminated, immediately add enough fluid such that
toggling the "RESET" switch results in the green "READY" light remaining illuminated even after the "RESET" switch
is released.
•
When finished, turn pump off to minimize liquid loss due to evaporation.
•
DO NOT leave the unit disconnected without power for extended periods of time (overnight or weekends). Cooling of
fluid will cause the microbes to go dormant. This will adversely affect the bioremediation process.
•
Bleach (chlorine), disinfectants, biocides and/or dumping of excessive oil may destroy the microbe colony, affecting
the system's cleaning ability. (Bio-Circle L, Ultra & Aero)
USING SINK AS SOAK TANK
•
To use unit as a soak tank, position the plastic stopper in the center drain. Do not remove the flexible rubber strainer. It is
best if parts to be cleaned are placed in sink before filling.
•
Turn on pump to begin fluid flow. Leave pump running and fluid flowing through either the flow-thru brush or flexible hose.
The fluid will drain back into the base when the liquid level reaches the drainage holes in the sink. This continuous flow
refreshes the soaking fluid with filtered and heated solution and supplies gentle agitation.
55D600 (795-45486)
SPECIFICATIONS AND DIMENSIONS
Operating Fluid Capacity
Tank Capacity
Overall Dimensions
Working Space
Soaking Depth
Maximum Part Weight
Pump Output
INSTALLATION AND OPERATION
12 to 30 Gallons
30 Gallons
43"L x 28-1/2"W x 38"H
35"L x 21-1/2"W x 15"D
9" Maximum
300 Pounds (Soak) / 150 Pounds (Shelf)
300 GPH
4 of 29
5/12/22
Publicidad
