Bras QUARK Manual De Instrucciones página 15

fastening hooks (see figure 6) and slide it out (see figure 7).
3
Slide the outer spiral out (see 3) and then Outside magnetic
rotor assembly (see figure 9).
4
Remove the bowl gasket from its seat (see figure 10).
figure 6
figure 7
figure 8
figure 9
figure 10
5
Dismantle the faucet assembly (see figure 11).
6
Slide the drip tray out and empty it.
7. 3. 2 CLEANING
IMPORTANT
Do not attempt to wash any machine components in a
dishwasher.
ATTENTION
Before any disassembly and/or cleaning procedure make
sure that the dispenser is disconnected from its power
source.
1
Prepare at least two gallons of a mild cleaning solution of
warm (45-60 °C 120-140 °F) potable water and dishwashing
detergent. Do not use abrasive detergent.
Important: if present, follow label directions, as too strong a
solution can cause parts damage, while too mild a solution will
not provide adequate cleaning.
IMPORTANT
In order to prevent any damages to the dispenser use
only a detergent suitable with plastics parts.
2
Using a brush, suitable for the purpose, thoroughly clean all
disassembled parts in the cleaning solution.
ATTENTION
When cleaning the machine, dump it, do not allow exces-
sive amounts of water around the electrically operated
components of the unit. Electrical shock or damage to
the machine may result.
3
In the same manner clean the evaporator cylinder(s) using
a soft bristle brush.
4
Rinse all cleaned parts with cool clean water.
15
figure 11