Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
1. Please use the card to measure hole position correctly and drill 3 holes of ɸ6mm.
2. Fix 3 expansion plugs into the holes.
3. Fix 3 screws into the explansion plugs with a spare space.
4. Insert the notch to the lower screw and fashten the whole lamp well.
5. Press the back button to adjust to the demanded working mode.
Notice
1. This is a solar powered lamp, please install it in a location where can get enough
sunshine.
2. Please note the lighting time depends on sunshine duration & weather.
3. The lamp will light up automatically at dusk.
4. Built-in intelligent IC is with over-charge, over-discharge and over-voltage protection.
Mode B: Automatically turns on to full
brightness (400lm) when motion is detected
in the range ≤ 6mtrs and then turns to 3%
brightness in 20 seconds of no motion.
Mode C: Automatically turns on to full
brightness (400lm) when motion is detected
in the range ≤ 6mtrs and then turns off in 30
seconds of no motion.
Notch
Button
Publicidad
