Energeeks EG-S002 Guía De Instalación Rápida página 24

•
Install the siren by screwing it to the wall at a
reasonable height, make sure that the rear anti-tamper
button is pressed when pressing against the wall.
•
Turn on the main switch and close the case.
Warning
If the siren has false alarms, the signal with the alarm
equipment may be low, or some radio-frequency
system is interfering with the signal, reset the siren and
re-link it, if the problem persists, change the location
of the siren to an area where the signal with the alarm
equipment is stable and does not receive interference.
To reset
•
Desarme la alarma para evitar el salto por sabotaje.
•
Disarm the alarm to a avoid from being triggered by
sabotage.
•
Remove the siren cover.
•
Press the connect button for 4 seconds until you hear
three beeps
•
Arm and disarm the alarm.
•
Press the connect button again for 4 seconds until you
hear the three beeps again.
•
The siren is reset and disconnected from the alarm
equipment.
•
Repeat steps 3, 4, and 5 of the installation guide to
link it again.
24