Hilti UH 700 Manual De Instrucciones Original página 26

Drilling in wood
Mixing emulsion paint
thin cement mortar,
tile adhesive,
gypsum plaster with mixing pad-
dle
4 Technical data
For details of the rated voltage, current, frequency and/or input power, refer to the power tool's
country-specific type identification plate.
If the tool is powered by a generator or transformer, the generator or transformer's power output must be
at least twice the rated input power shown on the rating plate of the tool. The operating voltage of the
transformer or generator must always be within +5 % and -15 % of the rated voltage of the tool.
Weight in accordance with EPTA procedure 01
Speed in 1st gear
Speed in 2nd gear
Maximum torque, 1st gear
Maximum torque, 2nd gear
Impact speed
Diameter, chuck
Tightening torque for change of chuck
4.1 Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the total
working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Noise emission values
Sound power level (L
WA
Uncertainty (K )
WA
Sound pressure level (L
Uncertainty (K )
pA
Total vibration
Hammer drilling in concrete (a
Drilling in metal (a )
h, D
Uncertainty (K)
18 English
Auger bits
Spade bits (not self-
tapping)
TE-MP 80
TE-MP 110
)
)
pA
)
h, ID
≤ 30 mm
≤ 40 mm
In 1st gear
recommended
In 1st gear
recommended
UH 700
2.6 kg
900 /min
2,500 /min
80 Nm
29 Nm
40,000 Nm
1.5 mm ... 13 mm
120 Nm
UH 700
109 dB(A)
5 dB(A)
98 dB(A)
5 dB(A)
UH 700
14.2 m/s²
4 m/s²
1.5 m/s²
273761
—
≤ 40 mm
—
—
*273761*