Publicidad
Idiomas disponibles
Idiomas disponibles
on button second. Your tool is now locked on
for continuous use. To switch off your tool just
depress and release the on/off switch.
3. VARIABLE SPEED CONTROL (SEE FIG. F)
Adjust the variable speed control to increase or
decrease the speed according to the material
and accessory to be used (also possible during
no load operation). Low speed will provide low
torque and high speed gives higher torque.
Rotate the variable speed control to achieve a
required speed by aligning the triangle symbol
with the letters from A to F. The speed increases
from A to F.
F
4. FORWARD/REVERSE ROTATION CONTROL
(SEE FIG. G1, G2)
Forward rotating: push the forward/reverse
rotation control to the right (the drill points away
from you). It is used for drilling.
Reverse rotation: push the forward/reverse
rotation control to the left (the drill points away
from you). It is used for remove a jammed drill
bit.
WARNING: Never change the direction
of rotation while the tool is rotating, wait
until it has stopped.
E
2
1
G1
G2
5. DRILL/ IMPACT ACTION SELECTOR
SWITCH (SEE FIG. H)
When drilling in masonry and concrete, push the
drill/impact action selector switch to the hammer
position "
".
When drilling in wood, metal and plastic, push
the drill/impact action selector switch to the drill
position "
".
H
33
Publicidad
