Be Cool wagon Manual De Instrucciones página 50

Idiomas disponibles

3_ Insert the ISOFIX connectors of the child car seat

into the corresponding ISOFIX anchors of the car, you

will hear them click locked and the display window will

show the green symbol. The window will display the red

symbol if the ISOFIX connectors are inserted incorrectly.

4_ Push the child car seat firmly against the backrest

of the vehicle seat. Shake the seat from side to side to

make sure it is securely attached.

5_ Adjust the child car seat in the forward facing

position, suitable for children of 100-150 cm, 1 reclining

position is available .

6_ Press the button to activate the SIP and close the car

door after the car safety seat has been installed.

7_ Place the child in the safety seat, adjust the headrest

to the right position, the guide hook should be slightly

higher (1-2 cm) than the child' s shoulders, and pass

the diagonal seat belt through the green guide under

the headrest, the lap belt must go through green hook,

both seat belts should pass through the green guide

under the armrest. Click the metal parts into the buckle

of the car seat belt. Check that the belt is not twisted

and tighten the seat belt by pulling the diagonal belt

upwards. Check that the lap belt is positioned as low as

possible, across the thighs and not around the tummy.

Don't use force-bearing points without markings.

Don't use the support leg when using the adult

seat belt

10. THREE-POINT CAR SEAT BELT

1_ Retract the support leg and store it in the base.

2_ Place the child in the safety seat, adjust the headrest