Palmer kyll Manual De Instrucciones página 13

USER MANUAL
kyll
CONNECTIONS AND OPERATING ELEMENTS
1. INPUT A / INPUT B
Line inputs with combo jacks (XLR / 6.3 mm jack) suitable for both unbalanced and balanced cabling.
Use shielded audio cables to connect a keyboard to the Line Isolation Box, for example.
2. OUTPUT A / OUTPUT B
Balanced line outputs with 3-pin XLR sockets. Use shielded audio cables to connect the Line Isolation Box to
a balanced input of a mixing console or audio interface.
3. LIFT / GND
Switch for disconnecting the ground connection from the input and output (ground lift). In the non-pressed posi-
tion, the ground connection is disconnected; the connection is established when the switch is pressed. The ability
to prevent a humming loop using the ground lift switch depends on the grounding of the connected device. It is
therefore possible that the switch is able to effectively reduce or eliminate humming when it is either up or down,
depending on circumstances.
CAUTION:
from mixers and audio interfaces etc. are muted during plugging. Otherwise, noise levels may cause
damage.
NOTE: Strong magnetic fields can cause humming. Therefore, do not position the Line Isolation Box near
strong magnetic fields (e.g. mains transformer).
EN
Connecting signal cables can cause considerable noise. Make sure that input channels
two channel line isolation box
passive
13