Publicidad
Idiomas disponibles
Idiomas disponibles
1.
GENERAL
We hope the purchase of this wood-burning appliance brings you plenty of heating pleasure.
Read these instructions carefully before installing and using the appliance. Keep these
instructions in a safe place. In the event of a problem with your appliance, please always
provide the model and serial number, which can be found on the appliance.
Your receipt of purchase is your proof of guarantee.
The appliance is delivered complete. Check the appliance immediately after delivery to confirm that it has
not been damaged during transport. If it has been damaged in any way, please inform your supplier
immediately, providing as many details as possible. Your appliance has been coated with heat-resistant
enamel that can withstand extremely high temperatures. Allow the appliance to burn at the highest setting
and ventilate the room thoroughly during its first hours of use. As the enamel cures, a non-hazardous
smell and/or some smoke may be emitted.
CAUTION
The appliance must be installed, connected and checked by an installation technician qualified to
national, regional, local and European standards and regulations.
WARNING
Wood-burning appliances get hot when in use. After installation of the appliance, the glass surface is
considered to be an active zone. The surface of the glass can become very hot!
Caution! You must take all reasonable precautions such as keeping children and vulnerable
people away from the immediate vicinity of any working appliances. Furthermore, wood-
burning appliances must never be installed on or against non-fireproof materials (curtains,
etc.).
Modification of the appliance is strictly forbidden.
Never place the appliance against or in a non-fireproof wall.
Flue gas discharge.
Connect the appliance to a suitable individual flue gas duct that is suitable for wood-burning appliances.
The appliance must not be connected to a shared discharge system. The flue gas duct must be clean and
gas-tight. Angles in the flue gas duct must never exceed 45 degrees. A T-piece with soot bag pipe must be
used at the rear connection.
The diameter of the flue duct must be at least equal to the connection size of the appliance. The draft in
the flue must be at least 12 Pa. A flue gas damper must be used in the event of a duct drawing too
strongly. Ensure the chimney is cleaned regularly. Follow the instructions of the duct supplier here. In the
event of a chimney fire, extinguish the fire in the appliance (e.g. with sand), close the chimney flap if
possible, and contact the fire brigade.
Product standards and regulations:
The Woody Loft wood-burning appliance has been tested in accordance with NEN-EN 13240+A2 and also
meets the following requirements:
*
DIN + standard
*
BimschV stufe 2
*
KB – Royal Decree
2.
FUEL
What fuel can you use and what should you pay attention to?
Good fuel is the "engine" of your appliance. Always use high-quality, well-dried wood. This will ensure you
get the most benefit from the fire and will prevent unwanted "side effects" such as excessive smoke
formation or spattering. What can you use?
1.
Hard woods such as oak, beech and wood from fruit trees. This wood gives a short flame and burns
for a longer period.
2.
Light woods such as birch, poplar, willow, alder and spruce. These types give a long flame but burn
quite quickly.
Installation and operating instructions
13
Trimline Woody Loft
Publicidad
