Publicidad
Idiomas disponibles
Idiomas disponibles
The sensor and bands should not
contact any part of your bike or shoe.
NOTE: The LED flashes green for five
seconds to indicate activity after two
revolutions.
5 Take a 15 minute test ride and
inspect the sensor and bands to
ensure there is no evidence of
damage.
Installing the Speed Sensor
NOTE: If you do not have this sensor, you
can skip this task.
TIP: Garmin recommends you secure
your bike on a stand while installing the
sensor.
1 Place and hold the speed sensor on
top of the wheel hub.
2 Pull the strap
around the wheel
hub, and attach it to the hook
the sensor.
10
The sensor may be tilted when
installed on an asymmetrical hub.
This does not affect operation.
3 Rotate the wheel to check for
clearance.
The sensor should not contact other
parts of your bike.
NOTE: The LED flashes green for five
on
seconds to indicate activity after two
revolutions.
Device Information
Charging the Device
To prevent corrosion, thoroughly dry the
USB port, the weather cap, and the
NOTICE
Quick Start Manual
Publicidad
