Publicidad
Idiomas disponibles
Idiomas disponibles
BEFORE FIRST USE
TOOLS REQUIRED: 4 mm hex drive bit, 10 mm wrench,
1. Install handle
Using drive and wrench, remove two bolts
from posts. Insert tubes over posts and line up the holes. With
tubes in position, reinsert two bolts supplied into either the upper
or lower holes and tighten until they are snug. For operator com-
fort, handle may be fixed in one of two positions.
After handle is installed, excess power cord may be tucked into
console.
NOTE: Locate the Accessory/Spare Parts Kit, which is
shipped in the filter basket. It contains two sets of impellers
and gaskets for servicing the pumpout pump. Remove the Kit
from the basket and keep it for future use.
2. Flush system lines.
freeze from the factory. Flush internal lines with fresh water prior
to use.
DO NOT drain used antifreeze on the ground or into storm drains.
Dispose of antifreeze only in an approved location. Observe local,
state, and federal laws when disposing antifreeze.
THE VT1200 IS NOW READY TO CONNECT TO A WATER SUPPLY AND A DRAIN.
49-091B VT1200-115V 2014-05
Unit may contain residual anti-
VISIT WWW.VERSACLEANSYSTEMS.COM
Plug sockets. Se-
cure plugs with clip
provided.
Handle may be
installed in
high or low
A. Flush cleaning head solution lines. Set unit up
for operation (see "Setup for Cleaning below), except
leave cleaning solution intake tubes disconnected
and direct pumpout discharge hose into a bucket or
suitable drain. Operate unit for a few minutes on a
hard, waterproof surface until discharge runs clear.
B. Flush accessory solution line. Set unit up for
accessory operation (see "Cleaning with Accessory
Tool/Upholstery Tool" below). Place accessory tool
end in a bucket of clean water and operate the
VC700 until discharge runs clear.
4
Legend Brands, Inc.
Publicidad
