Publicidad
Idiomas disponibles
Idiomas disponibles
STARTING PROCEDURE
1. Squeeze and hold Solution Control Lever
2. Turn Pressure Pump on.
3. Turn Vacuum on.
4. Squeeze and release pressure trigger several times
5. While squeezing the Solution Control Lever,
factory for a 900–1000 psi start-up pressure. Note: Pressure will increase slightly during operation. 950–1000 psi is
the target operating range. Use the Pressure adjustment knob to control pressure as needed.
You may now proceed with cleaning.
TIPS
• To manually pump out waste tank, press and hold pumpout switch to "Manual"
position.
Release switch to return to "Auto" mode.
• Attach brush ring for cleaning softer materials
slate travertine, etc.), and for resilient surfaces such as vinyl composition tile and linoleum.
• Attach smooth ring for cleaning harder surfaces
tured surfaces such as ceramic, quarried stone, and porcelain tiles.
To use unit with hand tool or wand,
adapter tube. Now attach tool to accessory vacuum inlet and accessory high pressure water outlet .
CLEANING PROCEDURES
NORMAL SOILS
1. Prespray
with VersaTile Step 1. See label for
dwell time.
2. Agitate surface
3. Extract
with VersaTile machine.
4. Dry
with sufficient airmovers to ensure rapid drying.
5.
Seal
(Optional)
with VersaTile Step 2 Penetrating
Seal.
READ CHEMICAL PRODUCT LABELS FOR DETAILED INSTRUCTIONS.
For routine floor care between VersaTile cleanings, we recommend the use of
VersaTile Step 3 damp mopping product.
TRANSPORTATION AND STORAGE
NOTICE: Handle the unit carefully. Do not drop, throw, or place the unit where it could fall. Rough treatment can damage
this equipment and may create a hazardous condition or void warranty.
• While moving unit, tilt unit back to lift vacuum head 1 to 2 in. above floor.
• Store and transport securely to avoid any damaging impact to internal parts.
• Secure during transport to prevent sliding and possible injury to vehicle occupants.
• Protect from freezing.
49-091B VT1200-115V 2014-05
with brush.
VISIT WWW.VERSACLEANSYSTEMS.COM
observe pressure gauge. The VT1200 is set at the
such as tile and grout, natural stone (marble,
first remove cap from the accessory vacuum inlet and insert vacuum
HEAVY OR GREASY SOILS
1. Prepare booster solution
and VersaTile Grease Release. See labels for instructions.
2. Agitate surface
3. Extract
with VersaTile machine.
4. Dry
with suitable airmovers to ensure rapid drying.
5.
Seal
(Optional)
Seal.
6
such as marble and concrete and manufac-
of VersaTile Step 1
with brush.
with VersaTile Step 2 Penetrating
Legend Brands, Inc.
Publicidad
