DeWalt D28499X Manual De Instrucciones página 39

or AC ........... alternating current
or AC/DC .... alternating or
direct current
...................... Class II
Construction
(double insulated)
n ........................ no load speed
o
n ......................... rated speed
...................... earthing terminal
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
Motor
Be sure your power supply agrees with the nameplate
marking. Voltage decrease of more than 10% will cause loss
of power and overheating. D
if this tool does not operate, check power supply.
Familiarization
Large angle grinders are designed for heavy material
removal in extended use applications.
SKU Description
D28499X 7" / 9" Angle Grinder 6,000
COMPONENTS (FIG. A)

WARNING: Never modify the power tool or any part
of it. Damage or personal injury could result.
Refer to Figure A at the beginning of this manual for a
complete list of components.
INTENDED USE
Your grinder is designed for professional grinding, sanding,
wire brushing, polishing or abrasive, cutting-off applications.
Do NoT use under wet conditions or in presence of
flammable liquids or gases.
Your grinder is a professional power tool. Do NoT let
children come into contact with the tool. Supervision is
required when inexperienced operators use this tool.
Keyless Guard
This allows for tool-free guard change and adjustment.
ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Attaching Side Handle (Fig. B)
The side handle 5 can be fitted to either side or the top of
the gear case in the threaded holes. The side positions are
designed for optimized balance in surface finishing and
grinding applications. The side handle must be used at all
times to maintain proper control of the tool. Before using
the tool, check that the handle is tightened se cure ly.
..................... safety alert symbol
..................... visible radiation
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
WALT tools are factory tested;
e
RPM
Fig. B
NoTE: The D28499X offers 5 handle locations for
additional versatility.
Rotating the Gear Case (Fig. C)
For applications in which a tool will be dedicated for uses
in edge grinding and finishing work, the gear case may be
rotated 90° left or right of its original position.
Fig. C
1. Remove the four corner screws attaching the gear case
to motor housing.
2. Without separating the gear case from motor housing,
rotate the gear case head to desired position.
NoTE: If the gear case and motor housing become
separated by more than 1/8" (3.17 mm), the tool must be
serviced and re-assembled by a D
Failure to have the tool serviced may cause brush, motor
and bearing failure.
3. Reinstall screws to attach the gear case to the
motor housing. Tighten screws to 20 in.-lbs. torque.
Overtightening could cause screws to strip.
Rotating the Rear Handle (Fig. D)
1. Unlock the rear handle by pulling out the handle re lease
lever 12 .
Fig. D
12
2. Rotate handle into available 0°, 30°, 60°, or 90° position
left OR right of center.
3. Push in the handle release lever.
4. Before turning the tool on, ensure that the handle is
locked into a position and the handle release lever
has returned to the original position flush with the
tool housing.
ENGlIsh
WALT service center.
e
37