Santoemma POWERTEC Manual De Uso Y Mantenimiento página 13

3. Pull backwards the spray/rinse nozzle. In this way the accessory is able to spray solution
at medium pressure. In order to spray at a lower pressure, push the nozzle forward.
4. To spray the solution, press the lever on the accessory. Spray solution uniformly on the
surface to clean, keeping the nozzle of the spray accessory at a distance of about 30-40
cm from the surface. It is enough to cover the surfaces to be cleaned and sanitized, with
a minimal quantity of chemical.
5. Proceed from the top to the bottom and cover all the surfaces to be cleaned.
While you spray the solution in the further areas, this acts chemically on the already sprayed
surfaces.
After spraying, it is necessary to leave the solution act for some minutes on the surfaces. If
the spraying step has required some minutes, the first surfaces to be sprayed are ready to
be rinsed.
The time necessary for the chemical action might vary according to the type of surface and
to the type of dirt. For a wall with average-smooth panes, it should be enough to leave the
chemical act for 2-3 minutes.
NOTE: We advise to wait the necessary time for the solution to perform its chemical action,
in order to obtain the maximum result.
In order to perform the rinsing, it is necessary to commutate the machine from the "spray
mode" to "rinse mode", as follows:
1. Turn the "spray/rinse" lever in "rinse" position, on the regulation panel, in order to
spray water only, without any chemical.
2. Check that the spray/rinse accessory is in the rinse position, by pushing backwards
the terminal part of the tool. In this way the accessory is able to spray rinse water at
the most appropriate pressure.
TIME NECESSARY FOR THE CHEMICAL ACTION
STEP B – RINSING AND FINISHING
13