Santoemma POWERTEC Manual De Uso Y Mantenimiento página 14

3. Press the lever on the accessory. We suggest to proceed rinsing the vertical surfaces
from the top to the bottom. By rotating the terminal part of the accessory it is also
possible to vary the width of the rinse flow.
Water used for rising will flow down along the walls, together with the solution and the dirt
removed. If the area cleaned has a drain hole on the hard floor, it is be possible to push the
liquid toward the drains, using the floor wiper.
STEP C – VACUUMING THE RESIDUAL LIQUID FROM HARD FLOOR
After completing the cleaning of the vertical surfaces, the sanitary fixtures and all the
surfaces to be cleaned, it is possible to vacuum the residual liquid from hard floor.
This operation is particularly useful in case there are not drain hole on hard floor in the
nearby.
To vacuum the liquid, proceed as follows:
1. Connect the machine to the floor tool, using the vacuum hose.
2. Switch on the vacuum motor.
NOTE: The capacity of the recovery tank is enough to vacuum all the liquid previously
sprayed with a full tank of the clean water tank. After vacuuming the residual liquid, do not
re-fill the clean water tank before draining the recovery tank. Furthermore, avoid to vacuum
liquid not sprayed by the same machine, but for example by other sources. In this case in
fact the quantity of water vacuumed into the recovery tank could be excessive for its
capacity. If this should happen, check often the level of the recovery tank.
14