UFESA CE7240 CALABRIA Manual De Instrucciones página 19

Pour the frothed milk into the espresso prepared; now the cappuccino is ready. Sweeten to taste and if
desired, sprinkle the froth with a little cocoa powder.
Press the ON/OFF switch to the "0" position to cut the power source o .
Note: we recommend you allow the maker to cool down at least for 5 min before makin co ee a ain.
Otherwise burnt odor may occur in your Espresso co ee.
MAKING HOT WATER:
1. With this function, you can pre-heat your co ee cup to ensure that the temperature of the co ee will
not decrease. So as to improve the co ee flavor.
2. Clean your co ee cup. After drinkin co ee, you can directly make hot water with this co ee maker
to clean the cups. This makes it more simple and convenient to clean the cups.
Methods:
1. Press the On/O switch to the "1" position; the Steam switch to "0" position, Co ee/hot water
selector to "0" position. The red lamp will be illuminated; waitin for a moment, the reen lamp will
be illuminated.
2. First, turn the steam control knob from "OFF" to "0" position in anti-clockwise. (Turn the knob with
at least 135 de ree.) Then press co ee/hot water selector to "1" position, and hot water will flow out
from the steam wand.
Note: At first the hot water will scatter from the steam wand. May let the steam wand outlet close to
the co ee cup wall. Thus at this moment, you need to pay attention to the protection of hot water
splash burns skin.
PRODUCING STEAM TO HEAT LIQUIDS
The steam wand (without the frothin device) can be used to make hot bevera es like drinkin
chocolate, water or tea.
Method:
Open the tank cover, remove the detachable tank and fill it with desired water, the water level should
not exceed the "MAX" mark in the tank. Then place the tank into the appliance properly.
Replace the tank, then connectin the appliance to power supply source.
Press the ON/OFF switch to the "1" position, the red lamp is illuminated.
Turn the steam control knob to "OFF" or "0" position, make the co ee/hot water selector on the "1"
position, the pump will pump water, when there is water flowin out, close the pump (co ee/hot water
selector to the "0" position) immediately, pressin the steam selector to the "1" position and waitin for
a moment, the appliance be ins to be heated until the reen lamp is illuminated, it shows the heatin
is finish.
Remove the frothin device from the steam wand.
Dip the steam wand into the liquid to be heated. Turn the steam control knob in anti-clockwise slowly
to start makin steam.
When the required temperature is reached, you can turn the steam control knob to "OFF" or "0" position.
Press the ON/OFF switch to the "0" position to cut the power source o .
19