GLW EC 65 Manual De Instrucciones página 43

START-UP
1. Selecting the installation site
• The installation site must be level and horizontal.
!
The conditions in the SAFETY chapter under Work Places must be observed.
2. Removing the protective cover
• Unscrew the screw (1).
• Pull off the protective cover (2).
3. Mounting the crimp die
Note installation position:
!
Small cross section at front.
Large cross section at back.
• Insert bottom die (1).
• Screw in screw (2) loosely.
• Insert top die (3).
• Screw in screw (4) loosely.
12/09
Figure 3 Removing the protective cover
Figure 4 Mounting the crimp die
8