GLW EC 65 Manual De Instrucciones página 45

START-UP
6. Centring the dies
Since the bores of the dies have a
!
slight clearance to the fastening
screws it is possible to offset the dies
to each other.
Centring / adjustment of the dies is
possible with the following adjustment
mode (steps 6 and 7).
• Press
+
•
+
• Push force range adjusting slide (3) to
position 1.
• Press the foot switch (4) and keep it pressed.
• The crimp die (5) closes slowly until it meets
with a resistance and centres itself.
• Release the foot switch (6).
If the foot switch is released before the
!
crimp die is closed, this opens
automatically, the adjustment mode is
ended and
12/09
simultaneously (1).
flash (2).
lights.
Figure 7 Centring the dies
10