Fanimation RADIUS LP7614LBN Manual Del Usuario página 15

5A. For use with light kit.
Connect the 2 single pin connectors from the LED
assembly to the 2 single pin connectors from motor
assembly. (Figure 5A)
NOTE: If you have installed your fan with the steel
cap, skip Steps 6 and 7.
6. Assemble the LED assembly to the light kit using
the two key slots. Replace the removed screw from
Step 3 and secure all three screws. (Figure 6)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
7. Secure the glass to light kit by twisting in a clockwis
direction. Twist the glass gradually
onto the light kit.
until it snaps
Do not over-tighten. (Figure 7)
Figure 5A
Light Kit
LED
Assembly
Light Kit
15
LED
Assembly
Steel Cap
Figure 5B
Figure 6
Figure 7
Light Kit
Glass