Tabla de contenido
Publicidad
Connecting
the appliance
After installing the appliance, wait at least
½ hour until the appliance starts up.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior (see Cleaning).
The socket should be easily accessible.
Connect the appliance to 220 240 V/
50 Hz alternating current via a correctly
installed earthed socket. The socket must
be fused with a 10 A fuse or higher.
If the appliance is to be operated in
a non European country, check on the
rating plate whether the indicated
voltage and current type correspond
to the values of your mains supply.
The rating plate is located in the
appliance at the bottom left hand side.
The mains connection cable may be
replaced by an electrician only.
Warning!
!
Never connect the appliance
to electronic energy saver plugs
(e.g. Ecoboy: Sava Plug) or to power
inverters which convert the direct
current to 230 V alternating current
(e.g. solar equipment, power supplies
on ships).
Setting the
temperature
- This refrigerator features a temperature
controller for the freezer section and
a temperature controller button for the
refrigerator section.
- The default setting of the temperature
control button for the refrigerator
compartment is 4 °C.
- The factory setting of the temperature
controller for the freezer section is 4.
Controls for Refrigerator
Compartment
The default setting of the temperature
control button for the refrigerator
compartment is 4 °C.
You can set refrigerator temperature using
the button temp.
You can select the required value from
7 settings.
en
23
Publicidad
Tabla de contenido
