Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
1. POWER ON/OFF (
By pressing this key, the unit is turned on or off. This unit is turned on by pressing any key.
2. FUNCTION SELECT BUTTON: BASS/TREBLE/BALANCE/FADER /
INITIAL VOLUME / ADJ / TA VOL / EON / DSP / TA SEEK / PI SOUND / RETUNE / MASK DPI
3. VOLUME UP/DOWN
Turning VOL knob (right/left) to adjust VOL/BAS/TRE/BAL/FAD. To select other functions, press
the VOL knob shortly until the desired functions are shown on the display. Figure 1 shows how to
control functions that are selected using the VOL knob.
1
SEL
Increase or decrease the volume by turning VOL knob (right/left). These buttons can be used to
adjust the BASS, TREBLE, BALANCE and FADER.
2 sec.
SEL
IN VOL
MASK DPI
SEL
Press and hold VOL knob to adjust INIT VOL /ADJ/TA VOL/EON ON//DSP/TA SEEK/PI SOUND/
RETUNE/MASK DPI
IN VOL:
Can adjust Initial Volume level using this mode.
ADJ:
Can adjust clock time. Turn VOL knob clockwise to set hours and counter clockwise to set minutes.
TA VOL:
Can adjust TA Volume (The volume level when Traffic announcement is transmitted).
EON:
Can selected EON condition, ON or OFF.
DSP:
Can select DSP mode (Classic, POP, Rock, Flat)
TA SEEK/ALARM
TA SEEK mode: When newly turned station does not receive TP information for 5 sec., the radio
retunes to next station which has not the same station (PI) as the last station, but has the TP
information.
In TA seek mode, the current station can be changed to the completely different station because
the unit searches TP station when the field strength of the current station is very weak, or the
current station has no TP signal.
TA ALARM mode: Any automatic retune mode is not activated, just can hear Beep sound.
PI SOUND
Action when 2 stations with different programme identification (PI) codes are on the same frequency:
SOUND: The radio switches to the new channel for a few seconds and then switches back again
MUTE: The radio is muted
RETUNE L/S
RETUNE L: Select 90 seconds as the initial time of automatic TA search.
RETUNE S: Select 30 seconds as initial time.
)
2
SEL
Fig. 1 Selection of sound control functions
1. VOL
2. BASS
SEL
ADJ
SEL
RETUNE
SEL
3
4
SEL
3. TRE
4. BAL
TA VOL
SEL
EON
PI SOUND
SEL
EN-5
5
SEL
SEL
5. FAD
SEL
DSP
TA SEEK
SEL
Publicidad
