GB
APPLIANCE CHARACTERISTICS
The cyclone vacuum cleaner is used to clean hard fl oors and carpets with an air stream. The vacuum cleaner does not require
dust bags. The air stream is set in a swirling motion inside the vacuum cleaner's container, which allows to separate the sucked in
impurities. The product is designed for domestic use only and may not be used in commercial applications. The correct, reliable,
and safe operation of the appliance depends on its proper use, so:
Reading and keeping the entire manual before the fi rst use of the appliance.
The supplier shall not be held liable for any damage resulting from failure to observe the safety regulations and recommendations
specifi ed in this manual.
ACCESSORIES
The vacuum cleaner is supplied with additional accessories in the form of a pipe and brushes for various purposes.
SAFETY INSTRUCTIONS
CAUTION! Read all of the following instructions. Failure to do so may result in electric shock,
fi re, or personal injury.
FOLLOW THE INSTRUCTIONS BELOW
Do not use the product in an explosive environment containing fl ammable liquids, gases, or
vapours. Do not place the appliance near any heat or fi re sources. Connect the appliance
only to the power network with the voltage and frequency indicated on the nameplate of the
appliance. The plug of the power cord must match the power socket. Do not modify the plug.
Do not use any power adapters to adapt the plug to the socket. An unmodifi ed plug, which
matches the socket, reduces the risk of an electric shock. After each application, unplug the
power cord from the power socket. Avoid direct contact with grounded surfaces such as pip-
ing, radiators and refrigerators. Grounding of the body increases the risk of an electric shock.
The appliance is intended for indoor use only. Do not expose the appliance to any precipita-
tion or moisture. If water and moisture enters the appliance, the risk of an electric shock is sig-
nifi cantly increased. Do not immerse the product in water or any other liquid. Do not obstruct
the ventilation openings and make sure they are clear. Obstructed and/or clogged ventilation
openings may cause the appliance to overheat. This can lead to damage to the appliance or
cause fi re or electric shock. Do not overload the power cord. Do not use the power cord to
carry, connect, or disconnect the plug from the power socket. Avoid any contact between the
power cord and heat sources, oil, sharp edges, and moving parts. Damage to the power cord
increases the risk of an electric shock. If the power cord is damaged (e.g. it is cut, its insula-
tion is melted), immediately unplug it from the wall socket, and return it to an authorised ser-
vice facility. It is not allowed to use the product with a damaged power cord. It is not allowed
to have the power cord repaired. It must be changed for a new one at an authorized service
centre. When using extension cords, use extension cords with power parameters such as
those shown on the appliance's nameplate. The cross-section of the extension wires shall
not be less than the cross-section of the wires of the power cord of the appliance. This should
be checked on the insulation of the power cord and the extension cord, or contact the man-
ufacturer of the appliance and/or the extension cord. If you notice any damage to any part of
the appliance, you must discontinue using it. In this case, the appliance must be taken to an
authorised service centre or replaced by yourself, if this is permitted by the user's manual.
O R I G I N A L
I N S T R U C T I O N S
11