LUND 67230 Manual De Instrucciones página 8

GB
PRODUCT OVERVIEW
The garment steamer is intended for ironing, brushing and cleaning clothes by means of steam jet. The product is intended for domestic
applications only, and not for any commercial use. The correct, reliable, and safe operation of the device depends on its proper use, so:
Read and keep the entire manual before the fi rst use of the product.
The supplier shall not be held liable for any damage resulting from failure to observe the safety regulations and recommendations
specifi ed in this manual. Use of the product for purposes other than those for which it was intended shall cause the loss of the
user's rights to the guarantee and under warranty.
ACCESSORIES
The product is delivered complete, but requires carrying out a number of preliminary actions described in further sections of the
manual, before starting operation. An outlet nozzle cap is supplied with the product.
SAFETY INSTRUCTIONS
Caution! Read all of the following instructions. Failure to do so may result in electric shock, fi re, or personal injury.
FOLLOW THE INSTRUCTIONS BELOW
Do not use the product in an explosive environment containing fl ammable liquids, gases, or vapours.
Before starting the product for the fi rst time, make sure that the product, its accessories, and the power cord have not been dam-
aged. If any damage is discovered, it is not allowed to start working with the product. Any damaged components, including the
power cord, must be replaced at an authorized facility. It is not allowed to repair the product on your own.
The product is intended for indoor use only. Do not expose the product to any precipitation or moisture. If water and moisture
enters the product, the risk of an electric shock is signifi cantly increased. Do not immerse the product in water or any other liquid.
Never point the steam jet at clothing that is on a person wearing it, at another person or animal.
Connect the product to the power network providing the voltages and frequencies indicated on the nameplate of the unit, exclu-
sively. The plug of the power cord must match the power socket. Do not modify the plug. Do not use any power adapters to adapt
the plug to the socket. An unmodifi ed plug, which matches the socket, reduces the risk of an electric shock.
A product with fi rst class electrical insulation must always be connected to an outlet equipped with a protective conductor. The
mains power supply should be equipped with a residual current fuse with a tripping current of 30 mA or less.
After each application, unplug the power cord from the power socket. Always disconnect the device from the power supply, if it is
left unattended, and before putting it away, disassembling, cleaning or fi lling with water.
Do not leave the device unattended when it is connected to the power supply.
Do not overload the power cord. Do not use the power cord to carry the product, connect, or disconnect the plug from the power
socket. Avoid any contact between the power cord and heat sources, oil, sharp edges, and moving parts. Damage to the power
cord increases the risk of an electric shock. If the power cord is damaged (e.g. it is cut, its insulation is melted), immediately unplug
it from the wall socket, and return it to an authorised service facility. It is not allowed to use the product with a damaged power cord.
It is not allowed to have the power cord repaired. It must be changed for a new one at an authorised service centre.
Disconnect the power cord from the power socket, before installing, removing, or adjusting any of the product accessories.
Make sure that the selected accessory has been installed correctly, before starting the product.
Do not overload the product. The temperature of the housing must not exceed 60 C. Overloading the product will accelerate its
O
wear and tear, lead to its damaging, and increase the risk of an electric shock.
The product must be kept under supervision at all times during operation. Do not leave the product unattended if it is connected
to the power supply.
The product is not to be used by children. Keep the product and its power cord out of the reach of children. It is important to ensure
that children do not see the product as a toy.
Children should not be allowed to clean or maintain the product without the supervision of an adult.
Keep the device and its power cord out of reach of children under 8 years of age if it is connected to the power supply or when
it is cooling down.
This product cannot be used by people with impaired physical and/or mental abilities, and by people without any experience in or
understanding of the operation of the product, unless they are supervised or instructed in the safe use of the product, so that they
understand the relevant operating risks.
The water tank cannot be opened during use.
Do not use the device if it has been dropped, if there are visible signs of damage or if it is leaking.
Never point the steam jet at yourself, other people or animals. Contact with hot steam can cause serious burns. Never fi ll the
product with a substance other than clean, cold water. In particular, do not use fl ammable substances such as alcohols, solvents.
Do not add any other substances, e.g. detergents, to the water.
O R I G I N A L I N S T R U C T I O N S
8