Descargar Imprimir esta página

Electrolux EUF2744AOW Manual De Instrucciones página 10

Ocultar thumbs Ver también para EUF2744AOW:

Publicidad

Idiomas disponibles

Idiomas disponibles

10
www.electrolux.com
Problem
The lamp does not work.
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the FastFreeze
or after changing the tem‐
perature.
Water flows on the floor.
Temperature cannot be
set.
DEMO appears on the
display.
The temperature in the
appliance is too low/too
high.
Possible cause
The temperature in the
appliance is too high.
The lamp is in stand-by
mode.
The lamp is defective.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The FastFreeze function
is switched on.
This is normal, no error
has occurred.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The FastFreeze or Shop‐
pingMode function is
switched on.
The appliance is in dem‐
onstration mode.
The temperature regulator
is not set correctly.
Solution
Refer to "Door Open
Alarm"or "High Temperature
Alarm".
Close and open the door.
Contact the nearest Author‐
ised Service Centre.
Refer to "Operation"/"Control
panel" chapter.
Wait a few hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "FastFreeze func‐
tion".
The compressor starts after
some time.
Attach the melting water out‐
let to the evaporative tray.
Switch off FastFreeze or
ShoppingMode manually, or
wait until the function resets
automatically to set the tem‐
perature. Refer to "Fast‐
Freeze or ShoppingMode
function".
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
Set a higher/lower tempera‐
ture.

Publicidad

loading

Este manual también es adecuado para:

Euf2744aox