Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLING THE DETECTOR
Assembling the detector is easy and requires no special tools. Just follow these
steps.
A
C
B
Depress the spring clip in the middle stem and insert it into the bottom pole (B)
aligning the clip with the hole.
Loosen the middle stem's lock nut in the direction of the
arrow. Then insert the upper pole stem (A) into the middle
stem. Turn the stem's lock nut in the reverse direction of the
arrow to lock it in place.
When you stand upright with the detector in your hand, the search coil is level
with and about 1/5 cm above the ground. You can lengthen or shorten the stem
basing on your height. After figuring out the suitable
length, then tighten the lock nut.
Unscrew the bolt of the control box (C) and hitch the
control box to the top stem. Then, insert the bolt into
the assembly hole on top stem and tighten it with the
box.
Wind the cable around the stem. Insert the search coil
cable plug into the five pin jack at the bottom of
control box'shousing.
Caution:
The search coil cable plug fits into the
connector only one way.
Do not force the plug or you could damage it.
15
Publicidad
