Publicidad
Idiomas disponibles
Idiomas disponibles
ADJUSTING THE SEARCH COIL
Loosen the knobs at the search coil's end, then adjust the
search coil to the desired angle. (The search coil should be
parallel with the ground.) Tighten the knobs just enough to
keep the search coil from rotating or wobbling.
INSTALLING BATTERY
You need one 9V alkaline battery to power your detector.
Cautions: use only fresh battery of the required size and
recommended type.
1. If the detector is on, turn the power off.
2. Press on the battery compartment cover and slide the cover
off in the direction of the arrow. Connect the battery with
the battery connector taking care of the polarity. Then put
the battery into the compartment.
3. Replace the cover.
Cautions:
Always remove old or weak battery; battery can leak chemicals that can destroy
electronic parts. If you do not plan to use the detector for a week or more,
remove the battery.
Dispose of old battery promptly and properly.
You can extend battery life by using earphones, which require less power than
the built-in speakers.
USING EARPHONES
You can connect a pair of stereo earphones (not
supplied) to the detector so you can listen to it
privately. Using earphones also saves battery power
and makes it easier to identify subtle changes in the
sounds you hear, for better detection results.
To connect earphones to the detector, insert the
earphones' 3.5mm plug into the EAR jack on the control box.
Note: The detector's internal speaker disconnects when you connect
earphones.
LISTENING SAFELY
To protect your hearing, follow these guidelines when you use earphones.
Set the volume to the lowest setting before you begin listening.
16
EAR
Publicidad
