Hilti TE 800-AVR Manual Del Usuario página 14

Trouble or fault
The power tool doesn't start.
The power tool starts and the
service indicator lights red.
The tool does not achieve full
power.
The chisel cannot be released
from the chuck.
9 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
10 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
Mode d'emploi original
1 Indications relatives au mode d'emploi
1.1 À propos de ce mode d'emploi
• Avant de mettre l'appareil en marche, lire impérativement ce mode d'emploi.
préalablement requise pour assurer la sécurité du travail et un maniement sans perturbations.
• Bien respecter les consignes de sécurité et les avertissements du présent mode d'emploi ainsi que celles
figurant sur le produit.
• Toujours conserver le mode d'emploi à proximité du produit et uniquement transmettre le produit à des
tiers accompagné de ce mode d'emploi.
1.2 Explication des symboles
1.2.1 Avertissements
Les avertissements attirent l'attention sur des dangers liés à l'utilisation du produit.
signalisation suivants sont utilisés :
DANGER
DANGER !
▶ Pour un danger imminent qui peut entraîner de graves blessures corporelles ou la mort.
10 Français
Possible cause
Generator in sleep mode
The service indicator lights.
Power reduction is active.
The extension cord is too long or
its gauge is inadequate.
The voltage provided by the elec-
tric supply is too low.
The chuck is not pulled back fully.
Action to be taken
▶ Apply a load to the generator
by connecting a second power
consumer (e.g. worklight).
▶ Have the power tool serviced or
repaired by Hilti Service.
▶ Press the power level selector
switch (observe the power level
indicator). Switch the power
tool off and then on again.
▶ Use an extension cord with
an adequate conductor cross
section. (1.5 mm² for lengths up
to 40 m; 2.5 mm² for lengths up
to 65 m).
▶ Connect the power tool to a
different electric supply.
▶ Pull the chuck back as far
as it will go and remove the
accessory tool.
C'est la condition
2064796
*2064796*
Les termes de