Publicidad
Step 31
å
Carefully stand your unit upright.
å
Position your unit in its final location. Turn the ADJUSTABLE FOOT (25E) downward until it touches the floor.
å
IMPORTANT: The ADJUSTABLE FOOT should not extend beyond the bottom edges of the LEGS (K and L).
å
Before fastening the DOOR to your unit, be sure the mounting screw is against the stops as shown in the right diagram.
If it isn't, loosen the adjusting screw and mounting screw to slide it against the stops. Then tighten the mounting screw.
å
Fasten a DOOR (Q) to each END (A) as shown in the lower diagram. Use the screws in the HINGES. You should start each
SCREW a few turns before completely tightening any of them.
å
See step 33 for DOOR adjustments.
L
Q
16
Turn the ADJUSTABLE FOOT
downward until it touches the floor.
Page 36
A
Floor
25E
Q
433851
17
16
17
Mounting
screw
Adjusting
screw
Hinge
L
A
K
www.sauder.com/service
Stop
Publicidad
