Publicidad
Step 4
å
Slide one of the LOWER END MOLDINGS (P) onto the END (A). Line up the groove in the LOWER END MOLDING over the
head of the SCREWS in the END.
å
NOTE: The LOWER END MOLDING is wider than the UPPER END MOLDING.
å
NOTE: The MOLDING should be even on both edges of the END.
å
NOTE: If the MOLDING comes up off of the SCREWS, remove it and slide it on again.
å
Repeat this step for one of the UPPER END MOLDINGS (O).
Shoulder
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the END.
www.sauder.com/service
P
A
433851
These edges
should be even.
These holes
must be here.
Shoulder
These edges
should be even.
O
Page 9
Publicidad
