GRILL MEISTER GGW 84 A1 Manual De Instrucciones página 23

•
Remove all of the individual components from the packaging and place them somewhere easily
accessible.
•
Remove all of the assembly materials from the packaging and place them somewhere easily
accessible.
•
Ensure you have the required tools at hand.
WARNING! When assembling the barbecue, make sure that the heads of the screws
always point outwards. This allows you to prevent injuries caused by protruding screws.
Below are instructions on how to assemble the barbecue in eight steps, including diagrams. Set aside
the required individual components and assembly materials.
Please note that some sheet metal parts will only contract and take on their final
positions during assembly because of their shape. For that reason, we
recommend initially hand-tightening the screws before tightening them using a
tool later on.
Step 1
 Hand-screw the two slat holders (15) to the wheel legs (13). Use the bottom hole of the slat
holder (15) and the middle hole of the wheel leg (13) to do this, see diagram. You will need a
screw (18), a washer (22) and a nut (20) in each case.
 Fasten the reinforcing bars (14) to the wheel legs (13). You will need a screw (18), a washer
(22) and a nut (20) for each one.
 Now fasten the reinforcing bars (14) to the slat holders (15). You will need a screw (18), a
washer (22) and a nut (20) for each one.
 Screw the wheel legs (13) and mounted slat holders (15) to the left side of the charcoal basket
(5). To do this, use the top hole of the wheel legs (13).
Please note: The three holes for assembling the wind guard in the charcoal basket (5) must
be facing the back. For each wheel leg (13) you will need two screws (18), two washers (22)
and two nuts (20).
 Now tighten all the screws.
GRILL MEISTER GGW 84 A1
English - 21