Publicidad
STEP 11
IMPORTANT! THE BACK PANEL IS A STRUCTURAL PART OF THIS UNIT AND MUST BE INSTALLED PROPERLY.
With the help of another person, carefully turn your unit
onto its front. Position back panel as shown. Align squarely
with edges of bottom, left panel and right panel. Using
screws (5), start each screw as shown but do not fully
tighten. Make sure back panel is aligned squarely and nail
(6) straight down into the three edges as shown. Now fully
tighten the screws (5).
5
5
B
5
(x9)
5
H
5
5
6
(x17)
5
5
5
Q
F
Assure that our unit is square.
Distance from corner to corner
must be equal as shown.
18
5
"raw surface"
Flush bottom edge of the back
panel with the bottom edge of
bottom (F).
6
Publicidad
