Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION & OPERATION
Priming Plug
Tee
Priming Plug
Tee
Water Supply
Water Supply
Foot Valve
Foot Valve
FIGURE 3 – CISTERN OR SHALLOW WELL INSTALLATION
To Power
To Power
Male Pipe to Male Hose Adapter
Male Pipe to Male Hose Adapter
Male Pipe to Male Hose Adapter
(Discharge)
Male Pipe to Male Hose Adapter
(Discharge)
Female Hose Connection
Female Hose Connection
FIGURE 4 – WALL MOUNTED TO PRESSURIZED SERVICE LINE
P15005 (02-15-23)
90 Elbow
90 Elbow
Male Pipe to Male Hose Adapter
Male Pipe to Male Hose Adapter
Female Hose Connection
Female Hose Connection
High Pressure
15 Feet
Hose
Maximum
High Pressure
15 Feet
Hose
Maximum
Male Hose
Connection
Male Hose
Connection
Gun Nozzle
Weeping Type ONLY
Gun Nozzle
Weeping Type ONLY
Service Line
Service Line
Gate Valve or Hose Bibb
Gate Valve or Hose Bibb
Male Pipe to Male Hose Adapter
Male Pipe to Male Hose Adapter
High Pressure Hose with two
Female Connections
High Pressure Hose with two
Female Connections
(Suction)
(Suction)
Gun Nozzle
Weeping Type ONLY
Gun Nozzle
Weeping Type ONLY
High Pressure Hose
High Pressure Hose
1209 0894
1209 0894
To reduce friction losses to a minimum, inlet (suction) line should be
short and have as few elbows as possible . Size the inlet according to
the chart below:
AVE.
THREADED
RECOMMENDED
GPM
INLET SIZE
INLET LINE SIZE
7
3/4" NPT
10
3/4" NPT
20
1" NPT
30
1-1/4" NPT
An inlet strainer will prevent suspended debris from
clogging pump.
The internal running surfaces of the pump and seals require
water lubrication for good, consistent operation. Allowing pump
to run dry will severely damage pump and seals.
Install a pressure gauge in pump inlet line. Keep at least two
pounds per square inch pressure (2 PSI) in inlet line whenever
pump is operating. If this is not possible, consult customer
service representative.
LUBRICATION
It is not necessary to lubricate pump or motor. The motor is
equipped with sealed ball bearings, lubricated for the life of
the bearing. The mechanical shaft seal in the pump is self-
lubricating and requires no adjustment. Disassemble pump to
replace seal (See "Maintenance", Pages 10 to 11).
OPERATION
Observe the following precautions when operating the pump.
Keep the motor dry! Do not direct stream from pump
discharge onto the motor!
HAZARDOUS PRESSURE. Do not run the
pump with discharge shutoff, as hose may burst or pump
may be damaged due to high temperatures.
Do not use a standard trigger gun with this pump. Use only
trigger guns with an automatic weeping feature. These
are available as accessories and are provided with three
nozzles. The smallest nozzle restricts the flow, allowing use
of a smaller water source. The two larger nozzles are used if
the water source will supply the pump's full capacity.
DO NOT run pump dry; to do so may damage the seal.
To avoid internal damage to pump, Do not operate with
water temperature above 175° F.
RECOMMENDED
DISCHARGE LINE SIZE
1"
1"
1"
1"
1-1/4"
1-1/4"
1-1/2"
1-1/2"
5
Publicidad
