Hilti NCR 060 II-A22 Manual De Instrucciones página 22

3 Description
3.1 Product overview
3.2 Intended use
The product described is an uninsulated, cordless, electro-hydraulic crimping tool.
It is designed for crimping connectors made of copper (Cu) or aluminum (Al).
Before use of the power tool, all live cables or other items carrying electric voltage within the area in which
the user is working must be switched off. If this is not possible, the corresponding safety precautions for
working in the proximity of live cables or equipment must be implemented and observed.
• Use only Hilti lithium­ion batteries of the B 22 series with this product.
• Use only Hilti-approved battery chargers to charge these batteries. More information is available from
your Hilti Store or from www.hilti.group
3.3 Possible misuse
• Do not use this hand-held product clamped in a fixed position or as a stationary device.
3.4 Coated crimping / pressing head
NCR 060C-A22
DANGER
Electricity presents a risk of fatal accident! Contact with electrically live conductors can lead to severe
physical injury and/or death.
▶ The product is not insulated! If you use the product in proximity to electrically live conductors, wear
personal protective equipment.
The crimping / pressing head of the NCR 60C­A22 has a PVC coating made up of two layers. The inner layer
of the PVC coating is red, the outer layer is black.
Before each use, inspect the black coating on the tool head for indications of damage or aging. If you
find such damage, the red coating is visible and/or the crush-hazard or electric-shock-hazard symbol
is no longer legible, do not use the crimping tool and contact Hilti Service.
3.5 Lithium­ion battery status display
The charge state of the Li-ion battery and malfunctions of the product are indicated by the indicator of the
Li­ion battery. The charge status of the Li­ion battery is indicated after one of the two battery release buttons
is short-pressed.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
18 English
1
Crimping / pressing head
@
Piston reset slider for use in case of fault or
;
emergency
Servicing and fault indicator (red LED)
=
Battery release button
%
Battery
&
Slot on both sides to fasten the Hilti retaining
(
leash
White LED to illuminate the working area
)
Control switch
+
Crimping / pressing ram (stepped)
§
Pivoting bar to open the tool head
/
Lever to lock/unlock the tool head
:
Meaning
State of charge: 75 % to 100 %
State of charge: 50 % to 75 %
State of charge: 25 % to 50 %
2207049
*2207049*