Publicidad
Idiomas disponibles
Idiomas disponibles
10. TROUBLESHOOTING
Symptom
Machine turns on but
it does not draw any
water or there is not
sufficient pressure.
Multi-spray nozzle
leaks.
Outlet pressure
increases suddenly.
Machine drains out
water after stopping.
Soap accessory
cannot spray out any
detergent.
2 in 1: Portable Power Cleaner/
Water Sprayer
Possible causes
Hydroshot is being held too high
from the water source.
NOTE: The higher the Hydroshot is
held in the air, the harder the pump
needs to work to draw water (up)
against gravity.
Hose filter is blocked.
The users garden hose is not well
connected to the machine.
Hose Quick-Connect Adapter gets
loose.
The filter is missing. (See Fig. R)
The filter screen is blocked. (See
Fig. R)
Pump, hose, or other parts
are frozen due to outside
temperatures.
Hose kinks.
An excessive amount of air can be
in the hose and Hydroshot.
The nozzle pattern does not spray
correctly.
Air built up within the hose or
pump.
Multi-spray nozzle is blocked.
There is water remaining in the
lance and pump after stopping.
Blockage in the soap bottle.
The machine is not connected to
the water source.
Solution
Hold the Hydroshot lower to the ground (less
than 5' off of the ground) to improve water flow.
Take out the hose filter and rinse the parts with
clean water. (See Fig. P1, P2)
Check and reattach the garden hose tightly. (See
Fig. D2)
Tighten the hose adapter securely with a wrench.
Contact customer service to request a
replacement part.
Clean the filter screen regularly.
Wait for the pump, hose or other parts to thaw.
Straighten out the hose.
If air builds up within the hose or pump, the
water pressure will drop.
1) Hold the Hydroshot lower to the ground (less
than 5' off of the ground) to improve water flow.
2) "Pre-fill the draw-hose" completely with water
to ensure all air is removed.
3) Operate the hydroshot without the lance or
nozzle attached to allow a higher volume of
water to quickly and easily flow throw the unit.
Once all air pockets appear to be removed,
reinstall the lance and nozzle.
4) Connect directly to a water spigot with garden
hose to clear all air from the system. Refer to
figures E1, E2, E3.
Make sure the nozzle pattern symbol aligns with
the indicator mark on tool.
Continue to operate the machine for a few
moments until leakage stops. Refer to
comments from above to remove air pockets.
Clear any visible debris with a small object such
as a paper clip. Replace with a new multi-spray
nozzle.
Remove batteries and hoses. Press trigger and
rotate the Hydroshot in various directions to
allow all water to drain.
Clean it with fresh water.
Connect to the water source before turning on
the machine.
19
EN
Publicidad
