AENO RC1S Guia De Inicio Rapido página 14

port on the cardboard is open. Close the lid. Plug the power and start to use again.
Make sure that the indicator flashes white slowly.
Docking station indicator Status
Indicator state
White indicator flashes slowly
White indicator keeps on
Red indicator flashes quickly
Red indicator flashes slowly
Maintenance
You may rinse side brushes ❼ with hot water or clean them up with a damp cloth.
To clean the dust container ❻, pull it out of the vacuum cleaner body by pressing
the dust container lock ⓭. Then, open the container and shake out dust and
debris into the basket (See Figure h). Open the latches and remove the pre-filter
mesh from the dust container, as well as the HEPA filter ❽ and the foam filter ❾.
Clean them all with a brush or a dry cloth. The water tank, the mop for cleaning
and the foam filter may be washed with water. The roller brush may be cleaned
after removing it from the device body by releasing the two latches.
ATTENTION! The water container is filled with distilled water only. Once wet
cleaning is completed, the water container should be first emptied of the
remaining water and left to dry.
Never rinse the dust container or the HEPA filter with water.
Troubleshooting
1. The vacuum cleaner does not turn on. Possible causes and solutions: Make
sure the power switch ⓮ is turned on, and that the vacuum cleaner or the
remote control batteries are charged, and that the distance from the remote
control to the vacuum cleaner is no more than 5m. Try to start the vacuum
cleaner via the AENO app. When the vacuum cleaner is on the charging
station, it may not respond to commands from the remote control.
aeno.com/documents
Meaning
Docking station works normally
Docking station is vacuuming
Dust bag is not placed properly
Suction pipe or port are blocked
14