Cinematic light up box with black letters and characters for your home
SAFETY INSTRUCTIONS
-
PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS
•
Be sure to turn the light box off when unattended.
•
Rechargeable batteries should not be used.
•
Do not mix old and new batteries.
•
Always insert the batteries in the correct polarity.
•
When the power cable is being used, the batteries should be removed.
•
Batteries should be replaced by an adult.
BOX CONTENTS
-
•
Light box
∙ DC power input (1)
∙ Power on/off switch (2)
∙ Battery port for AA batteries (3)
•
Letters & characters
•
USB power cable
SETTING UP YOUR LIGHT BOX
-
Either:
1.
Open the battery cover (3), and insert 6 x AA batteries into the battery
port (3) and replace the cover.
Or:
2 of 22 | English
2.
Connect the supplied DC power cable to the DC power input (1) on the
side of the Light Box. Connect the other end of the cable to a 5 V USB port.
Switch on the power button (2) and the Light Box will illuminate. Press the
button down when using batteries (II) and press the button up when using
USB (I).
If you want to mount your Light Box on the wall, there are holes on the back
for mounting.
CHOOSING YOUR MESSAGE
-
1.
IMPORTANT: Make sure to remove the plastic film on each letter before
use.
2.
Slide the interchangeable clear plastic letters and characters into the
slots on the front of the light box to create fun words and phrases.
3.
If standing the light box up, ensure it rests on the support legs at the
bottom.
REPLACING THE BATTERIES
-
1.
Open the battery cover (3), and remove the old batteries.
2.
Replace them with 6 new AA batteries.
3.
Replace battery cover.
SPECIFICATION
-
Material
ABS black and acr ylic white
Dimension
A5 - H15 x W20 x D5 (cm) / H6 x W7 .9 x D2 (inches)
A4 - H22 x W30 x D6 (cm) / H8. 7 x W11.8 x D2. 4 (inches)
A3 - H30 x W42 x D6 (cm) / H11.9 x W 16.5 x D2 .4 (inches)
Power supply
6 x AA battery or USB power cable
Weight
600 g / 21 oz
Battery type
6 x AA batteries required
English | 3 of 22