Publicidad
Idiomas disponibles
Idiomas disponibles
washer (36) and nut (37).
Insert the nut (37) into the conical
spring washer (36) as shown.
Use the assembly key (19) to secure it.
6. Remove the Allen key (18) and
transport protection (11).
Dismantling is carried out in rever-
se order.
Removing/mounting
the protective cover
extension
If using the 3-tooth blade (
protective cover extension (14) must be
removed.
If using the spool cap (
tective cover extension (14) must be
attached.
Removing the protective cover
extension:
1. Unlock the lock (38) for the protective
cover extension (14) using a Phil-
lips-head screwdriver on the side of
the string cutter (13).
2. Remove the protective cover extensi-
on (14).
Mounting the protective cover
extension:
1. Slide the extension (14) onto the pro-
tective cover (1). Begin on the side
without the string cutter (13).
2. Slide the extension (14) up until it
clicks into place.
Mount the spool cap
The protective cover must be
mounted with the extension (14)
when using the thread spool.
10), the
12), the pro-
(See Chapter: "Removing/
mounting the protective cover
extension")
Do not replace the non-metallic
filaments of the spool end with
metallic filaments! Risk of in-
jury!
1. Remove the rechargeable batteries.
2. Place the device on the ground in a
stable position.
3. Block the mounting spindle (34) using
the hexagon socket wrench (18) as
depicted.
4. Place the thin washer (35) on the
mounting spindle (34).
5. Screw the spool cap (12) anticlockwi-
se back onto the mounting spindle (34).
Dismantling is carried out in
reverse order.
Extend the thread
Attention! Thread remnants can
be projected and lead to injuries.
Your device is equipped with a doub-
le-string activated touch control, i.e. the
two strings are extended when you tap
the cutting head on the ground.
1. Hold the device in operation over a
grassy area and lightly tap the cutting
head a few times on the ground. This
causes the thread to lengthen.
2. The thread cutter (
the protective cover extension
(
14) cuts the thread to the desired
length.
GB
13) inserted into
129
Publicidad
